Digidata 1320 manual

Digidata® or series digitizer running with earlier versions of AxoScope or pCLAMP. If you will no longer be running any of these items, uninstall them from your system before you begin this installation procedure. _Digidata A user www.doorway.ru Page 7 Friday, Aug PM. such as a Digidata® or series digitizer running with earlier versions of AxoScope or pCLAMP software. If you will no longer be running any of these items, uninstall them from your system before you begin this installation procedure. Note: Before installing the software from a CD-ROM, contact. The Digidata A and A are high-resolution, low-noise digitizers intended for precision scientific applications. The Digidata A digitizes at an aggregate speed of kHz; the Digidata A digitizes at an aggregate speed of kHz. Unless otherwise indicated, references to the Digidata A also apply to the Digidata www.doorway.ru Size: KB.

Data were acquired through a Digidata digitizer. Signals were ampli fied through a Multiclamp B ampli er (Molecular Devices), sampled at 20 kHz, and filtered at 10 kHz using Clampex10 (Molecular Devices). Clampfit10 (Molecular Devi-ces) and Igor5 Pro (WaveMetrics) were used for data analysis. Membrane currents were measured with an Axopatch A patch-clamp amplifier coupled to a DigiData interface (Axon Instruments, Union City, CA, USA) or with an EPC-9 patch-clamp system (Heka-Electronics, Lambrecht/Pfalz, Germany). The time course of current change was monitored by repetitively applying (every 5 s) alternating step pulses. Details for steps (1)-(5) can be found in Axon's Digidata Series Operator's Manual. 1) Install the Axon SCSI card in a PCI expansion slot. 2) Attach the Digidata to the SCSI card and switch on the computer and 3) Install the AxoScope software supplied with the Digidata

Details for steps (1)- (5) can be found in Axon’s Digidata Series Operator’s Manual. 1) Install the Axon SCSI card in a PCI expansion slot. 2) Attach the Digidata to the SCSI card and switch on the computer and 3) Install the AxoScope software supplied with the Digidata 4) Reboot the computer. Details for steps (1)-(5) can be found in Axon’s Digidata Series Operator’s Manual. 1) Install the Axon SCSI card in a PCI expansion slot. 2) Attach the Digidata to the SCSI card and switch on the computer and 3) Install the AxoScope software supplied with the Digidata Digidata in the Digitizer field and then press the Configure button. The Configure Digidata x dialog reports whether a A or A is installed. It also displays the SCSI ID number and the serial number of the device. The Power-on Holding Levels set the voltage on both Analog Out channels at the time that the Digidata A/A is.